Hi All, Built a Wilson 2 and have a spare MKS Gen 1.4 available. Would that work with this printer or would I have to use the RAMPS 1.4 board. I tried using it but couldn't seem to get the code to compile with it. Do I have to change input mappings? Thanksby bbondura - Prusa i3 and variants
Well the one I shorted it against a power supply. The second one, I have no idea. I was feeding filament and the driver popped. Checked everything and can't figure out why it popped. Checked continuity of the motor to determine the pairs and I was correct. Voltage was good too.by bbondura - Duet
Have a guy at work that could replace the chip. The chips that I am finding are tmc2660 PA. Is that correct?by bbondura - Duet
Ok, I have the Axis all moving in the correct direction. Still lhaving a few issues one is technical and the other I believe is my lack of knowledge. 1. My X driver blew out when setting it up, therefore I had to remap the driver to number 4. How do I get my endstop to match that move? I tried moving the connection to correspond with that but I don't see how it would trigger the motor. I'm sureby bbondura - Duet
Thank You David! That was a huge help. As soon as I get home from work today I'll give that a shot. I believe your explanation led me to two issues. 1. My X and Y is mixed up. My Y goes left to right and my X goes front to back. That needs to be the other way around. 2. Secondly, I was under the impression home was rear left, not front left. 3. I believe my endstops are set incorrectly. I haveby bbondura - Duet
Hi all, first post here. I just built a corexy after the Spauda build on Thingiverse. I used the DuetWifi board instead of the RAMPS board. I'm having issues setting up my endstops and homing positions. It seems as though my endstops don't stop movement. Secondly, I can't for the life of me figure out the homing on this. Where is 0? Where is + and where is - ? Does anyone have this build that hasby bbondura - Duet