QuoteTurboaddiction Maybe you could share your copy to help the less experienced of us on getting this setup and working? Im working on getting this all setup and for me ill just have a lot of trial and error. But maybe at the least we will get this going with help as a group. Here's a link to the configuration.h and configuration_adv.h I am using with RC8 for my Reprap Guru. Note: you shouldby MostTornBrain - Prusa i3 and variants
QuoteCutterNorth Right. Sorry. Everything is connected correctly and securely. Here is the information on my printer. Have you tried calling RepRapGuru? Based on feedback on Amazon, their tech support is supposed to be pretty good.by MostTornBrain - Prusa i3 and variants
QuoteCutterNorth Well. Everything was going great for about a week. We completed several small print jobs and were getting familiar with different materials. Then the heated bed stopped reading the temperature. It just reads 0. The LCD says it knows when a target temperature has been assigned, but nothing happens. Motors and other sensors work just fine. I can heat and cool the extruder juby MostTornBrain - Prusa i3 and variants
QuoteTyborg I fixed the stepper drivers that I fried. ... I have been able to get prints out of the machine, but only by scaling them on the Y and X axis by 25% because the 10 mm cube I printed measured 7.5mm/7.5mm/10mm. I've had this printer for about a month and a half, so I'm beginning to discouraged. Sounds like your firmware is not using the correct number of steps for the X and Y axis.by MostTornBrain - Prusa i3 and variants
Quoteadlammons I am running REPRAP_GURU_MARLIN_V.2 but it doesn't include auto bed leveling. MARLIN 1.1.0RC8 does have auto bed leveling. However, I can't tell if it would be an issue to use it instead. Is there a newer version of the Marlin software? Or, can I just load the Marlin-1.1.0-RC8? I've switched to the RC8 version of Marlin and it is working well for me, however I have not enabled tby MostTornBrain - Prusa i3 and variants
QuoteDavidKing Here are two questions: 1. how to set in the slicer so that the both bed and nozzle temperature automatically cool down after the printing? Right now, only the nozzle temperature cool down and the bed temperature remain as it is during the printing 2. is there an instruction on how to use the LCD controller? Thanks 1. I use Slic3r. With it I added this to "Custom G-Code" undby MostTornBrain - Prusa i3 and variants
The blue rectangle is a mount for the cable chain. It clips onto the stepper motor - no screws needed, so it is easily removable. It's a modified version of this: I printed the horizontal version but used a connecting link from the chain model rather than one that sticks up so high. Regarding the 1st fan shroud, I custom designed it to fit my Prusa Guru, so it should fit a lot better than oby MostTornBrain - Prusa i3 and variants
QuoteHas anybody been able to find an extruder cooling fan shroud that will work with this extruder? I recently made one - it is here: It works pretty well - print quality is significantly better with the shroud, especially when printing single small items. Before using this I'd have to print multiple copies of a small item at the same time, otherwise it would get melty looking. I've alsoby MostTornBrain - Prusa i3 and variants