I'm not familiar with RCBugFix, is that a branch of the Marlin firmware? Is it likely to give me any diagnostic information? Right now my suspicion is that something has gone wrong with the Rambo board that makes the current firmware fall over. The firmware is old but had been working fine for nearly 2 years so I'm not sure how updating the firmware would help unless it has additional status repby train_depot - Firmware - Marlin
I probably should have changed the title of my initial post because it doesn't respond to any command after the init reset. No response to the jog commands or home commands in Pronterface. Cura doesn't work either. After the initial connect when the fans shut off and then restart, I get no response from the printer. Cura's log says ... Listening for engine communications on 49674 Closing downby train_depot - Firmware - Marlin
My MakerGear M2 has suddenly decided to stop responding to commands. It does the normal reset when you start the connection but then the firmware never seems to respond after sending back the SD card status is okay. Sending a M105 command generates no response and no more led flashes on the TX side. I see Rx led flash each time I send a command but no response after the initial reset. What couldby train_depot - Firmware - Marlin
I've given to trying to figure out how to fix horrible performance and switched to Cura. Even though I couldn't find a Makergear M2 profile and had to come up with my own settings, it immediately gave me far superior results.by train_depot - Slic3r
I'm a bit of a nube at this but I get seemingly random layers added to some of my designs, the layers aren't there in the STL file but they are definitely there in the gcode. What could the reason be? None of that brown stuff should be there in that layer.by train_depot - Slic3r