Here you go: ;FLAVOR:Marlin ;TIME:7176 ;Filament used: 10.6086m ;Layer height: 0.2 ;Generated with Cura_SteamEngine 3.4.1 M190 S65 M104 S205 M109 S205 M82 ;absolute extrusion mode G21 ;metric values G90 ;absolute positioning M82 ;set extruder to absolute mode M107 ;start with the fan off G28 ;move X-Y-Z to min endstops M420 S1 ;Enable Mesh leveling G92 E0 ; zero the extruded length G1 X35Y10Z0.2by M1k3 - Firmware - Marlin
Hi, Yes, i see the gear of my Titan extruder turning the "wrong" way (i.e. Retracting)by M1k3 - Firmware - Marlin
Hi All, My extruder seems to retract about 3-4 mm just before starting to print, this menas that it will only print half of my "purge line" Could you please tell me what's wrong? This is my "start" Gcode: ;FLAVOR:Marlin ;TIME:2826 ;Filament used: 2.57272m ;Layer height: 0.25 ;Generated with Cura_SteamEngine 3.4.1 M190 S60 M104 S210 M109 S210 M82 ;absolute extrusion mode G21 ;metric values G90by M1k3 - Firmware - Marlin
Problem solved! it wasn't the drivers, it wasn't the ramps and it wasn't the Arduino. Eventually, the culprit was Marlin, I downloaded the marlin bugfix build, and I might have screwed up the config, or there is a problem in the bugfix build for my specific situation. What I also found was that on the bugfix build I used about 58% of the Arduino memory, and on the "stable" build, I used about 4by M1k3 - RAMPS Electronics
Quick update, i ran the ramps1.4 test sketch RAMPS1.4_TestCode.pde Here everything runs perfect, stepper moves perfect (lots of torque!) and the LED's of the mosfets turn on and off. This makes it pretty clear my problem is in the Marlin settings, what could be set wrong in marlin for this to happen? i'm using the #define MOTHERBOARD BOARD_RAMPS_14_EFB setting.by M1k3 - RAMPS Electronics
Yes, the potentiometer is facing the power input of the RAMPS board. I just found out the following: The wiring is right, the two pairs are next to each other on the ramps board (black-red and blue-green). if i move the axis on the LCD screen by 0.1mm increments the stepper whines untill i reach 2.0mm and then RAMPS crashes (LCD freezes) Also, there is no resistance whatsoever on the stepperby M1k3 - RAMPS Electronics
Hi All, I'm new here, my name is mike and about 6 months ago I bought an Anet A6. Because this was not the quality printer I wanted, I made some pretty big modifications: - Added aluminum frame based on the Anet AM8 (https://www.thingiverse.com/thing:2263216) - Added Bowden setup with original E3D V6 Since the mainboard of Anet is also pretty crappy, I wanted to change this to RAMPS 1.4 (especby M1k3 - RAMPS Electronics