Ok thanks, it would have been so nice ! Do you think it's a hard work to test if it works ?by acca - Firmware - Marlin
Hello, I'd like to use a Mks Tinybee Board (esp32 based) to repair my ultimaker 2 printer. Is that possible to setup Ulti_controller to use with this board please ? Thanksby acca - Firmware - Marlin
My bad I was using homedir 1 instead of -1 for z axis Now I have the switch connected to zmax endstop and bltouch to zmin endstop and used for homing Thanksby acca - Firmware - Marlin
And is that possible to keep the switch for security ?by acca - Firmware - Marlin
Hello, I'm making a homemade printer using marlin I have a bltouch and a z endstop switch (approx at z=155mm) When I launch homing, the z endstop switch is used, is that the normal behaviour ? I'd like the bltouch to be used, is that possible ? Safe ? Thanksby acca - Firmware - Marlin