I was sent a PM which made me realize that I never posted my solution here. With the set up I have, the solid state relay only has an on/off ability so using the bang bang heating method was what I needed to have enabled and not PID. Through talking with some people we're pretty sure the relay was rapidly turning on and off to try to regulate the bed temp but it's not really designed for switchiby JMS728 - Firmware - Marlin
QuoteDust Step 1 Identify the motherboard. The linked marlin is either BOARD_RAMPS_14_RE_ARM_EFB or BOARD_ARCHIMAJOR The RAMPS_14_RE_ARM_EFB only has 5 stepper drivers, the config has #define EXTRUDERS 2 so there are no free extruders to use as Y2 The BOARD_ARCHIMAJOR seems to have 5 extruders. This is a real oddball controller, people have been working on adding support for it since 2017...by JMS728 - Firmware - Marlin
I'm working on a board from Ultimachine and you can access the Marlin files here. The printer is a modified Gigabot from re:3D. The current configuration of the printer is one X, 2 Y, and 2 Z steppers, same for the endstops, dual extruders, and it uses a RepRapDiscount full graphic smart controller When compiling the firmware directly after downloading with no changes I have no issues. When I eby JMS728 - Firmware - Marlin
QuoteRoberts_Clif After converting to Marlin 2.0.0 alpha again use WinMerge as the lines were closely matched to see for transfers to newer version of marlin 2.0.x. An the variable names again remain somewhat constant. Sorry could not actually help with this problem, I hope by comparing the files you find a difference that fixes it.. Just to confirm, you're recommending that I initially move mby JMS728 - Firmware - Marlin
Hey y'all I just upgraded the firmware on my printer from 1.1.8 to 2.0.4 yesterday and I ran into a couple of issues. Bed Related Hardware: Azteeg X3 PRO AD8495 Temperature Sensor Crydom DR24D12 SSR VIKI 2.0 When heating, the bed SSR status light is on until it gets within 10oC of the target temperature and then it starts rapidly blinking. I tried heating at the standard 60oC but it kept stoppby JMS728 - Firmware - Marlin