Thanks for the reply These are my config files I have already enabled 2 temp sensors Could you tell me where i can configure cooling fans?by Captain roast - Firmware - Marlin
I recently bought an MKS TINYBEE main board for a homemade machine and uploaded marlin 2.1.2 to it. Everything works fine and it's printing ok as far as controlling the hardware goes. One issue is that in the repetier software or in the WEBUI over wifi that the board has, there is no sign of a heated bed or cooling fan or anything like that, even though there are outputs for 2 nozzle heaters, 2 fby Captain roast - Firmware - Marlin
update: the RAMPS is ok and has no short. the problem is the Arduino. it may either be a defective unit or a fake but it is definitely not working correctly. the A7 and A2 pins are shorted through the green ON indicator LED. is that normal?by Captain roast - General
QuoteDust use ramps test code super simple, moves all stepper motors back and forward, and toggles mosfets on and off (so unplug heaters) no checks, no configuration, Thank you for the reply. i've tested the ramps board and the problem is that now the stepper when connected to the Y axis slot moves in only one direction and gets unpowered when expected to move in the other direction, i.e..by Captain roast - General
Also can someone please tell me what the pin numbers in pins.h correspond to? Because they are kind of confusing to me. The only things i've changed in the attached firmware zip are the configuration.h and pins.h files. Note that i haven't finished the setup. I haven't even finished the hardware of the printer so if you see anything weird don't be alarmed. The problem is that the Y axis, which isby Captain roast - General
I am in the process of building a custom 3d printer setup using the ramps 1.4 and a mega 2560. Everything works except the Y axis on its dedicated pins. I've since switched the pins to the E1 pins since i could not get it to work but i'd very much like to get it to work as i might add a second extruder later down the road. Things i've tested: -All the drivers are working. I've switched them and uby Captain roast - General