Prusa i3 Rework Bill of materials
English • العربية • български • català • čeština • Deutsch • Ελληνικά • español • فارسی • français • hrvatski • magyar • italiano • română • 日本語 • 한국어 • lietuvių • Nederlands • norsk • polski • português • русский • Türkçe • українська • 中文(中国大陆) • 中文(台灣) • עברית • azərbaycanca • |
Introduction | Bill of materials | Y-axis assembly | X-axis assembly | Connecting X-axis and Z-axis | Motor assembly
X and Y-axis motions | Heated bed assembly | Extruder assembly | Electronics and wiring | Marlin Firmware
Contents
Printed parts
Extruder
Smooth and threaded rods
- 2x Smooth rod Ø8x320 mm
- 2x Smooth rod Ø8x350 mm
- 2x Smooth rod Ø8x370 mm
- 2x Threaded rod M5x300 mm
- 4x Threaded rod M10x210 mm
- 2x Threaded rod M10x380 mm
Mechanical parts
Heated bed
Electronics
Screws, nuts and washers
If using the SainSmart Endstops then you will need 2 M3 flat head screws per endstop as the SainSmart endstops has a bad design flaw that gives absolutely zero clearance for the two lower screws as the wiring harness is too close to the pcb and over laps some of the 2 bottom open holes (wiring harness points downward at a 90 degree angle).
Aluminium frame
- 1x Single frame
- 1x Heated bed mount