Generation 1 firmware
Contents
Generation 1 Firmware
Building the RepRap PIC firmware under Linux
This page gives instructions on how to compile all the PIC firmware on a Linux system.
Programming RepRap PIC chips
This page gives instructions on how to use a conventional PIC programmer to do in-circuit programming of the PIC chips in the RepRap controllers above.
Stepper motor timings
This page describes how the PIC stepper controller boards do timing to get different stepper motor speeds.
Extruder heater control and temperature measurement
This page describes how the PIC extruder controller board senses temperatures and uses that information to control its heater.