Re: Bed adhesion issues October 29, 2011 08:35PM |
Registered: 14 years ago Posts: 689 |
Re: Bed adhesion issues October 29, 2011 09:01PM |
Registered: 13 years ago Posts: 1,780 |
Quote
Nudel
build surface has to be spotless, and tall objects can be knocked off on rare occasions. At 50C the pieces stick so good to the plate I can't remove them without damaging the parts. For larger or difficult prints I really don't want to mess up, I still print at 50C and lower the temp to get the parts off when I'm done. But at 48C I can pick off finished parts without too much force, and I don't have to bother with changing temperatures. If I go any higher the first layers of the prints deform.
Re: Bed adhesion issues October 29, 2011 09:41PM |
Registered: 13 years ago Posts: 2,947 |
FFF Settings Calculator | Gcode post processors | Geometric Object Deposition Tool Blog |
Tantillus.org | Mini Printable Lathe | How NOT to install a Pololu driver |
Re: Bed adhesion issues October 30, 2011 11:10AM |
Registered: 14 years ago Posts: 689 |
Re: Bed adhesion issues October 30, 2011 01:29PM |
Registered: 13 years ago Posts: 1,352 |
Re: Bed adhesion issues October 30, 2011 09:22PM |
Registered: 12 years ago Posts: 119 |
Re: Bed adhesion issues October 31, 2011 04:24AM |
Registered: 12 years ago Posts: 972 |
Re: Bed adhesion issues May 20, 2014 05:37AM |
Registered: 10 years ago Posts: 4 |
Re: Bed adhesion issues May 20, 2014 06:47AM |
Registered: 12 years ago Posts: 972 |
Re: Bed adhesion issues May 20, 2014 06:32PM |
Admin Registered: 11 years ago Posts: 3,096 |
Re: Bed adhesion issues May 23, 2014 12:05PM |
Registered: 10 years ago Posts: 24 |
Quote
Ohmarinus
Haha, this is great, a thread necromancer came along, and then misan, the original last poster of almost 3 years ago, immediately replies
Anyway, to add, I have great hopes in a PEI surface (PolyEtherImide) and am currently looking what is the best way for me to obtain an affordable place of PEI.
Re: Bed adhesion issues May 24, 2014 03:15PM |
Registered: 10 years ago Posts: 41 |
Re: Bed adhesion issues May 24, 2014 11:15PM |
Registered: 10 years ago Posts: 439 |