Slic3r Home Page
A word of warning to all the Slic3r fans out in RepRap TV land:
Slic3r 9.2 does not properly position the first layer Z height:
IT WILL LEAVE IT AT ZERO
-> If you are the kind of guy who "over squishes" their first layer, you will be in for a surprise as your nozzle drags through your print bed.
->If your printer survives the first layer, the print will be destroyed anyway, as the second layer will rise to the appropriate height and now extrude plastic in mid air
It seems that this problem is present when using the "Lift" feature, but I have read conflicting reports...
Edited 2 time(s). Last edit at 09/05/2012 04:58PM by Idolcrasher.