X,Y,Z Steps Calibration Help April 02, 2013 07:47AM |
Registered: 11 years ago Posts: 11 |
Re: X,Y,Z Steps Calibration Help April 02, 2013 08:03AM |
Registered: 14 years ago Posts: 3,742 |
Re: X,Y,Z Steps Calibration Help April 02, 2013 08:43AM |
Registered: 13 years ago Posts: 1,797 |
Re: X,Y,Z Steps Calibration Help April 02, 2013 08:52AM |
Registered: 14 years ago Posts: 3,742 |
Quote
jamesdanielv
rather than calculating by the pulley teeth should you not calculate by the circumference of the pulley around motor shaft? 200*16steps* 1mm/ pulley circumference should give the steps per mm.
Re: X,Y,Z Steps Calibration Help April 02, 2013 01:38PM |
Admin Registered: 17 years ago Posts: 7,879 |
Surely 1/32 if they are moving half as much as they should.Quote
rhmorrison
It looks like they are set to 1/8 stepping.
Re: X,Y,Z Steps Calibration Help April 02, 2013 01:53PM |
Registered: 11 years ago Posts: 11 |
Re: X,Y,Z Steps Calibration Help April 02, 2013 07:43PM |
Registered: 13 years ago Posts: 643 |
Re: X,Y,Z Steps Calibration Help April 02, 2013 07:55PM |
Registered: 11 years ago Posts: 11 |
Re: X,Y,Z Steps Calibration Help April 02, 2013 08:07PM |
Registered: 13 years ago Posts: 643 |
Re: X,Y,Z Steps Calibration Help April 03, 2013 02:47AM |
Registered: 14 years ago Posts: 3,742 |
Quote
nophead
Surely 1/32 if they are moving half as much as they should.
Prusa i3 Microstepping October 30, 2013 08:39AM |
Registered: 10 years ago Posts: 12 |
Re: X,Y,Z Steps Calibration Help October 30, 2013 09:22PM |
Registered: 10 years ago Posts: 1,433 |