NEWBIE THAT NEED HELP !!!

I GOT A PRUSA I3X A WHILE BACK AND IM NOW ABOUT COMPLETED THE BUILD. THE VIDEOS ON YOUTUDE HELP WITH THE MAJORITY OF THE BUILD BUT STOPPED RIGHT AFTER THE LCD INSTALL . IM LOST ON HOW TO CONNECT ALL THE ELECTRONICS. WHERE CAN I FIND INSTRUCTION, OR VIDEOS...PLEASE HELP!!! ( SORRY FOR THE ALL CAPS, IM NOT YELLING. I HAVE BAD EYES AND HAVE A HARD TIME LOOKING AT SMALL LETTERS ON THE SCREEN)

google images '3d printing boards' find your board, then find the schematic/wireing diagram.

then look up which ever firmware your using, probably 'marlin'

take yu time on the read up..

X axis is the horizontal bars that the cariage goes left and right on.
Y axis is the bed, travels towrds you and away from you
Z axis is the screw bars that go up and down
E0 is narmaly yur exstruder.

next come you tube, theres loads for prusa's.

im a newb too btw.

Also, turn the caps lock key off. No need to shout.

Quote
cvera1945
I HAVE BAD EYES AND HAVE A HARD TIME LOOKING AT SMALL LETTERS ON THE SCREEN

Then you should use BIG FONTS or set your screen resolution such that you can read the letters on your screen!

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse