oxygen barriers for sla 3d printers May 17, 2016 01:00AM |
Registered: 8 years ago Posts: 4 |
Re: oxygen barriers for sla 3d printers May 17, 2016 03:25AM |
Admin Registered: 16 years ago Posts: 13,891 |
Re: oxygen barriers for sla 3d printers May 17, 2016 08:35AM |
Registered: 10 years ago Posts: 1,401 |
Re: oxygen barriers for sla 3d printers May 17, 2016 10:36AM |
Admin Registered: 16 years ago Posts: 13,891 |
Quote
ggherbaz
For a bottom up SLA, salt water will distort the image projected by the projector or laser.
Re: oxygen barriers for sla 3d printers May 17, 2016 06:13PM |
Registered: 8 years ago Posts: 4 |
Quote
... with salt-water you don't need oxygene, as its only used to prevent curing of the resind while in contact with the bottom surface.
The only "drawback" with a fluid membrane is the inconsistent surface while pulling the object up, so the inner areas of voluminous parts won't be precise leveled, but slightly koncave, until the resin from the outside will refill the cavities again ...
Re: oxygen barriers for sla 3d printers May 17, 2016 06:26PM |
Admin Registered: 16 years ago Posts: 13,891 |
Re: oxygen barriers for sla 3d printers May 17, 2016 06:36PM |
Registered: 8 years ago Posts: 4 |