Welcome! Log In Create A New Profile

Change Marlin Z_MAX_POS with gCode ?

Posted by DaveOB

DaveOB

Change Marlin Z_MAX_POS with gCode ?
October 12, 2017 04:05PM

Registered: 11 years ago
Posts: 126

In my Marlin config I have the setting :

#define Z_MAX_POS 300

I am extending the Z axis to 400mm temporarily for a print.

Is there a gCode that I can use to change the Z_MAX_POS to 400 without having to reflash the Arduino ?

Reply Quote

Floyd

Re: Change Marlin Z_MAX_POS with gCode ?
October 12, 2017 04:58PM

Registered: 12 years ago
Posts: 770

How can you temporarily grow your printer 100mm?
Why not just set it at 400mm and leave it there.

Reply Quote

DaveOB

Re: Change Marlin Z_MAX_POS with gCode ?
October 12, 2017 05:01PM

Registered: 11 years ago
Posts: 126

Hi

Because my Z axis at 300mm fits in my heated enclosure for ABS prints.

Not very often that I want to increase the Z to 400 or 600, so prefer to change it with gCode if possible

Reply Quote

dc42

Re: Change Marlin Z_MAX_POS with gCode ?
October 12, 2017 06:30PM

Registered: 12 years ago
Posts: 14,691

There was a gcode defined to set the axis length many years ago (M208), but according to the Gcode wiki at [reprap.org] Marlin uses M208 for a different function.

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].

Reply Quote

DaveOB

Re: Change Marlin Z_MAX_POS with gCode ?
October 13, 2017 12:35AM

Registered: 11 years ago
Posts: 126

Quote
Floyd
How can you temporarily grow your printer 100mm?

it's a home modified i3 design that has makerslides and threadbar on the Z axis that I can change up to the limit of the threadbar ( 900mm )