Welcome!
Log In
Create A New Profile
Home
>
General
> Topic
Advanced
Slowing down feedrate to the end of layer
Posted by
sliceheart
Forum List
Message List
New Topic
sliceheart
Slowing down feedrate to the end of layer
February 15, 2019 05:03AM
Registered: 8 years ago
Posts: 34
I have been using Kisslicer lately and have notice that reduces the feedrate at the end of the external perimeter. A great thing I think, there is a way to do in Slic3r, Cura or Simplify3D?
Reply
Quote
obewan
Re: Slowing down feedrate to the end of layer
February 15, 2019 05:34AM
Registered: 7 years ago
Posts: 759
Look at coasting In cura,does very similar.
Edited 1 time(s). Last edit at 02/15/2019 05:35AM by obewan.
Reply
Quote
sliceheart
Re: Slowing down feedrate to the end of layer
February 15, 2019 07:32AM
Registered: 8 years ago
Posts: 34
Coast is also a great thing, but not the same. I use it with simplify3D, works well but some materials print better with the slowing trick.
Reply
Quote
dc42
Re: Slowing down feedrate to the end of layer
February 15, 2019 08:30AM
Registered: 10 years ago
Posts: 14,672
Both coast-to-end and slowing down at the end of a line are poor substitutes for properly-implemented pressure advance.
Large delta printer [
miscsolutions.wordpress.com
], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod
Disclosure: I design Duet electronics and work on RepRapFirmware, [
duet3d.com
].
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login