Makerfarm

Inherited a makerfarm 10" prusa i3v.

Apparently makerfarm is no more? Curious what happened? Can't find an archive that doesn't lead back to makerfarm.com which is no longer.

My printer needs a going through particularly to check wiring. Some wires are disconnected.

I'm looking for wiring diagrams, makerfarm original assembly instructions, calibration instructions, start-up & troubleshooting etc.

How generic is my printer regarding electronics, wiring and firmware?

Thanks in advance.

Assembly videos for Makerfarm i3 are available here: [www.youtube.com]

---

Thingiverse ID Alan1279

Many thanks for the link, This will help a
lot!

Probably got one of these in it;-

[reprap.org]

Totally generic if a bit quaint for the hardware. Don't know what firmware they supplied but Marlin 1.19 is adequate (current firmware).

There are LOADs of ways to tweak it.

Edited 1 time(s). Last edit at 11/03/2021 02:11AM by DragonFire.

Good to know!

Should I worry that the youtube vids might disappear like Makerfarm.com?

It can be erratic even with manufacturers that are still selling.

You should at least have more of an idea where the wires connect.