Hi,

i recently got a broken artillery sidewinder x1 from a friend to tinker or repair.

it uses and MKS gen L v1.0 board and I updated the marlin to the newest version.

in regular intervals i get a min temp error on the bed. this is a common problem on the machine an I will change the thermistor cable soon.

however i can see any temp drops while in use. the heating curve look fine. and there are not noteworthy fluctation in the temps and none that are as severe to trigger a min temp.

any idea what else could cause min temp?

Incorrectly calibration of your PIDTEMP or PIDTEMPBED can cause this.

I would try adjusting PIDTEMP or PIDTEMPBED again

---

Computer Programmer / Electronics Technician