Hey everyone
So I have a Panelolu2 ('P2') running on RAMPS 1.3, however I cannot get the click wheel encoder to work with my version of Marlin.
My printer was calibrated and printing fine before going down the P2 route.
The version of Marlin I am using (from ErikZalm) is a since updated version of the Think3DPrint3D one they recommend to download, has all my calibration ready and it has support for Panelolu2 built in so I figured I might as well stick with that so after un-commenting the relevant sections and uploading my P2 turns on, recognises the thermistors but the click wheel does nothing.
So to test the click wheel was working I downloaded T3P3's version of Marlin, uploaded it and the click wheel was fully responsive although not recognising I had a heated bed.
So does anyone know where to start to get the P2 working? If any more info is needed please let me know! Ideally I'd like to stick with the updated firmware since it is supposed to support it but I'm not sure what I am missing.
Thanks smiling smiley