Hi all,

I'm currently busy building a cnc router and I've been searching a while now for some firmware that supports CNC spindle on and off as well as a full graphic smart controller 128 x 64.

Kind regards
Marinus

I believe repetier firmware should suffice
You need to enable CNC mode in the tools tab

[www.repetier.com]

Hi,

I tried using Repetier, but Arduino IDE fails to compile the sketch. I keep getting errors like, "operator '>' has no left operand" and I know now to fix that there should be values on both sides, but they are for the temp control that I won't be using..

I've attached the Repetier.ino file.