Hello!
I have a generic question I don't understand. I'm building a corexy machine with duet board and rrf. The machine motion in xy direction is around 400x400mm but the bed is only 300x300. My homing is in one of the corner at 0,0. How do I define the bed (work) area? My bed starts around 50,50 and ends around 350,350. I was, ok maybe it is in the slicer, not in the printer config but I don't see such option in cura either?

See [docs.duet3d.com].

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].