Welcome! Log In Create A New Profile

Dual effector height adjustment for nozzles

Posted by sungod3k

sungod3k

Dual effector height adjustment for nozzles
January 01, 2016 11:40AM

Registered: 11 years ago
Posts: 805

Hi,

im gearing up to get a dual nozzle setup on my delta. I have two different hotends that might not have the same height and washers under the mounting plates might not be the most sensible tuning mechanism.

While looking for effector design I didnt find any that had an adjustment mechanism for that, so im wondering how this is supposed to be done?

Cheers

Reply Quote

nebbian

Re: Dual effector height adjustment for nozzles
January 02, 2016 09:25AM

Registered: 8 years ago
Posts: 916

I know that this doesn't help your situation, but the chimera has grub screws to allow you to adjust the height of each nozzle. The chinese clones are about the same price as a single hotend, which means that it's a no-brainer to get one of those instead of another 'normal' hotend.

Reply Quote

sungod3k

Re: Dual effector height adjustment for nozzles
January 02, 2016 09:55AM

Registered: 11 years ago
Posts: 805

Well i thought about chimera and cyclops im just waiting for some more reports on contermination. I bought normal hotends since there are some setup issues that I need to test anyway without disturbing my original setup.

Its probably a bit finicky but if I glue nuts on the top of the effector then I can make a screw advanced space similar to the endstop adjusters.