Welcome! Log In Create A New Profile


X axis motor issue

Posted by tepmurc 
X axis motor issue
May 08, 2013 03:17PM
I've just finished buliding my Huxley and started the commissioning. My y-axis, z-axis, and extruder motors work as they should when I send the commands from Pronterface. But the x-axis motor just vibrates.

I've tried increasing the voltage (by turning the pot), doesn't work. I've tried even different wire configurations, but no difference.

I wired the x-axis motor into the y-axis connectors and it worked fine, so I know the motor is fine.

Any suggestions on what to do?
Re: X axis motor issue
May 22, 2013 05:33PM
Update: it seems the motor controller chip was at fault. Reprappro sent me a replacement board.
Sorry, only registered users may post in this forum.

Click here to login