I bought a ramps fd Version 1A board (yeah now i know I jumped the gun a bit ) to plug into my due to control some motors. I thought I test it with one of my Panucatt SureStepr SD8825 stepper drivers taken from a BeBoPr+ board. The Panucatt driver is a drop in replacement for pololu drivers but my silly problem is I do not know which way round to insert the panucatt driver on the ramps board. I cannot seem to find any information on that. I am hoping that the alignment would be the same as Ramps 1.4 and assuming that is the case I am hoping that someone would point me to a diagram showing which way round the driver board should be.