X, Y, & Z End Stops Constantly Triggering July 15, 2016 07:53PM |
Registered: 7 years ago Posts: 7 |
Re: X, Y, & Z End Stops Constantly Triggering July 15, 2016 07:58PM |
Registered: 7 years ago Posts: 84 |
Re: X, Y, & Z End Stops Constantly Triggering July 17, 2016 09:22PM |
Registered: 7 years ago Posts: 7 |
Re: X, Y, & Z End Stops Constantly Triggering July 18, 2016 11:01AM |
Registered: 7 years ago Posts: 84 |
Re: X, Y, & Z End Stops Constantly Triggering July 19, 2016 11:21AM |
Registered: 7 years ago Posts: 7 |
Re: X, Y, & Z End Stops Constantly Triggering July 19, 2016 12:37PM |
Registered: 7 years ago Posts: 84 |
Re: X, Y, & Z End Stops Constantly Triggering July 19, 2016 05:58PM |
Registered: 7 years ago Posts: 7 |
Re: X, Y, & Z End Stops Constantly Triggering July 20, 2016 12:56AM |
Registered: 10 years ago Posts: 344 |
Re: X, Y, & Z End Stops Constantly Triggering July 21, 2016 02:53PM |
Registered: 10 years ago Posts: 651 |
Re: X, Y, & Z End Stops Constantly Triggering July 26, 2016 03:49PM |
Registered: 7 years ago Posts: 9 |
Quote
Open the Configuration.h file/sketch/tab and scroll Down to the @section homing - around line 330 or so.
Make sure you do not have 2 // in front of #define ENDSTOPPULLUPS. If you have, then remove them, upload the firmware to your printer and redo the tests we just did in Pronterface.
Re: X, Y, & Z End Stops Constantly Triggering July 27, 2016 05:10PM |
Registered: 7 years ago Posts: 7 |