Print Stretched Vertically(height) January 17, 2019 02:12PM |
Registered: 5 years ago Posts: 15 |
Re: Print Stretched Vertically(height) January 17, 2019 04:56PM |
Registered: 9 years ago Posts: 465 |
Re: Print Stretched Vertically(height) January 21, 2019 07:41PM |
Registered: 6 years ago Posts: 1,863 |
Re: Print Stretched Vertically(height) January 21, 2019 08:48PM |
Admin Registered: 13 years ago Posts: 7,002 |
Re: Print Stretched Vertically(height) January 22, 2019 02:27AM |
Registered: 6 years ago Posts: 1,007 |
NO !Quote
SupraGuy
..... Though the number of teeth SHOULD tell the story, it does not, because the belt radius itself adds some travel to the belt when it goes around the pulley. I found that my steps/mm were a little under the nominal to get the dimensions that I expected.