Is this magnetic bed save-able? January 30, 2019 11:03AM |
Registered: 5 years ago Posts: 4 |
Re: Is this magnetic bed save-able? January 30, 2019 01:00PM |
Admin Registered: 13 years ago Posts: 7,002 |
Re: Is this magnetic bed save-able? January 31, 2019 03:16AM |
Registered: 12 years ago Posts: 2,470 |
Re: Is this magnetic bed save-able? January 31, 2019 03:20AM |
Registered: 12 years ago Posts: 2,470 |
Re: Is this magnetic bed save-able? January 31, 2019 10:54AM |
Registered: 5 years ago Posts: 4 |
Re: Is this magnetic bed save-able? February 01, 2019 02:37AM |
Registered: 12 years ago Posts: 2,470 |
Re: Is this magnetic bed save-able? February 02, 2019 06:32AM |
Registered: 5 years ago Posts: 4 |
Re: Is this magnetic bed save-able? February 02, 2019 08:05AM |
Registered: 6 years ago Posts: 1,007 |
Quote
BoKKeR
The bottom part is glued correctly and won't move at all. This is the top "magnetic attachment" part that got damaged when the PLA started to wrap and the magnetism wasn't enough to hold it down anymore. I will try to warm it up and let it straighten out. I used it only on 60c max, survived around 10 small prints and it shit the bed on the first big one. Literally.
Re: Is this magnetic bed save-able? February 02, 2019 09:11AM |
Registered: 5 years ago Posts: 4 |
Re: Is this magnetic bed save-able? February 02, 2019 10:41AM |
Registered: 6 years ago Posts: 1,007 |
Re: Is this magnetic bed save-able? February 02, 2019 11:45AM |
Registered: 12 years ago Posts: 2,470 |
That’s whati meant. You need an additional top layer on the top magnetic foil to make this work. PEI, FR4, steel or whatever you like, i would not use glass thoughQuote
BoKKeR
Oh God No! Please check the original products link. It consists of 2 and magnetic Sheets. One you glue down on the bed and one that you put on top. The one on top is sticking to the one on the bottom. I printed on the one on the top but it started to wrap at the edges. I would say that the top sheet has lost its magnetism