Autolevel not compensating correctly March 05, 2019 02:42PM |
Registered: 10 years ago Posts: 197 |
Re: Autolevel not compensating correctly March 05, 2019 04:04PM |
Admin Registered: 13 years ago Posts: 7,005 |
Re: Autolevel not compensating correctly March 05, 2019 05:24PM |
Registered: 10 years ago Posts: 197 |
Re: Autolevel not compensating correctly March 05, 2019 07:57PM |
Registered: 10 years ago Posts: 197 |
Re: Autolevel not compensating correctly March 06, 2019 12:06PM |
Registered: 7 years ago Posts: 619 |
Quote
foul_owl
Send: M48 X150 Y150 P20
Recv: Mean: -0.693944 Min: -0.696 Max: -0.692 Range: 0.003Recv: Standard Deviation: 0.000719
0.7 micron stdev seems pretty good to me...
Re: Autolevel not compensating correctly March 06, 2019 04:11PM |
Registered: 10 years ago Posts: 197 |
Re: Autolevel not compensating correctly March 08, 2019 08:21PM |
Registered: 10 years ago Posts: 197 |
Re: Autolevel not compensating correctly March 08, 2019 09:00PM |
Registered: 6 years ago Posts: 1,863 |
Quote
foul_owl
1. After flashing firmware that updates probe offsets, *always* run M502 to load these new settings from the firmware. I was trying to adjust these settings but getting no effect due to this issue.
2. My start up code is now:
G28
G29
M420 S1
Re: Autolevel not compensating correctly March 19, 2019 04:08PM |
Registered: 6 years ago Posts: 265 |
Re: Autolevel not compensating correctly March 24, 2019 08:16PM |
Registered: 10 years ago Posts: 197 |