Mendel90 Kit ABS looks not good.
Posted by Smuk3D
|
Mendel90 Kit ABS looks not good. November 03, 2013 11:26AM |
Registered: 6 years ago Posts: 138 |
Hi
i have build the heatshield and clean the glass with alcohol or aceton.
the bed at 130 works fine.
the hotend have 230 degree but see the picture.
extrudine fine but something is wrong
z is calibrated just now
plz help me
i have build the heatshield and clean the glass with alcohol or aceton.
the bed at 130 works fine.
the hotend have 230 degree but see the picture.
extrudine fine but something is wrong
z is calibrated just now
plz help me
|
Re: Mendel90 Kit ABS looks not good. November 03, 2013 12:14PM |
Registered: 6 years ago Posts: 46 |
|
Re: Mendel90 Kit ABS looks not good. November 03, 2013 01:41PM |
Registered: 6 years ago Posts: 138 |
|
Re: Mendel90 Kit ABS looks not good. November 03, 2013 02:38PM |
Admin Registered: 12 years ago Posts: 7,822 |
It is hard to tell from the photo as there is no scale but it looks like the upright bit is getting too hot. You could try increasing the minimum layer time or printing two at a time.
Something is wrong with the bottom layer as well. Perhaps too high.
[www.hydraraptor.blogspot.com]
Something is wrong with the bottom layer as well. Perhaps too high.
[www.hydraraptor.blogspot.com]
|
Re: Mendel90 Kit ABS looks not good. November 06, 2013 03:22PM |
Registered: 6 years ago Posts: 138 |
Sorry, only registered users may post in this forum.