Y end stop testing January 20, 2014 06:02AM |
Registered: 10 years ago Posts: 23 |
Re: Y end stop testing January 20, 2014 08:58PM |
Registered: 10 years ago Posts: 859 |
Re: Y end stop testing January 21, 2014 03:45AM |
Registered: 10 years ago Posts: 14,672 |
Quote
adsoftware
As far as I've read, an LED near the Y motor pins on the board should indicate that the Y end stop is alive. But only darkness here on my end. Is there a way to test whether the end stop actually works? Can I see a response in the UI if the end stop has been hit?
Re: Y end stop testing January 21, 2014 04:57AM |
Registered: 10 years ago Posts: 23 |