Slic3 question January 28, 2014 05:18PM |
Registered: 10 years ago Posts: 20 |
Re: Slic3 question January 28, 2014 05:25PM |
Registered: 10 years ago Posts: 103 |
Quote
Ormerod276
I printed out the fan duct and it ended up with the ducts filled in even though the SW model shows open slots, the stl file bought in to Slic3 showed slots in the 3d view and of course the part supplied in the original kit had open slots. I looked at the gcode and it shows that the slots are filled in so I am guessing it is something I have set in Slic3? Any thoughts please?
Re: Slic3 question January 28, 2014 05:26PM |
Registered: 10 years ago Posts: 147 |
Re: Slic3 question January 29, 2014 02:58AM |
Registered: 10 years ago Posts: 1,230 |
Quote
PaulHam
Suggestions from someone that doesn't really know much.
Check to see if you have slic3r v1 not 0.9.9
Download dc42's slic3r ini's and try again.
I think you will get better prints.
Re: Slic3 question January 29, 2014 06:48AM |
Registered: 10 years ago Posts: 103 |
Re: Slic3 question January 29, 2014 09:06AM |
Registered: 10 years ago Posts: 2,472 |