Slic3r Profile for 0.3mm Noozle June 12, 2014 02:19AM |
Registered: 9 years ago Posts: 138 |
Re: Slic3r Profile for 0.3mm Noozle June 12, 2014 02:35AM |
Registered: 10 years ago Posts: 378 |
Re: Slic3r Profile for 0.3mm Noozle June 12, 2014 05:51AM |
Registered: 9 years ago Posts: 138 |
Re: Slic3r Profile for 0.3mm Noozle June 12, 2014 12:20PM |
Registered: 10 years ago Posts: 327 |
Quote
muggi
Thanks, i will so this an test the settings
Re: Slic3r Profile for 0.3mm Noozle June 12, 2014 04:21PM |
Registered: 9 years ago Posts: 138 |
Re: Slic3r Profile for 0.3mm Noozle June 12, 2014 04:41PM |
Registered: 10 years ago Posts: 14,672 |
Quote
muggi
Hi
So i tested the settings. My opinion is that the Lines Are not close enough together to make a good surface. So the Start of printing is a very critical Event.
Does someone a Hint for us to reduce the size between Lines????
Re: Slic3r Profile for 0.3mm Noozle June 12, 2014 05:58PM |
Registered: 10 years ago Posts: 378 |
Re: Slic3r Profile for 0.3mm Noozle June 12, 2014 11:23PM |
Registered: 9 years ago Posts: 138 |