Web interface not updating, 1.09m-Dc42 and 1.07 January 14, 2016 10:23AM |
Registered: 9 years ago Posts: 23 |
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 14, 2016 01:30PM |
Registered: 9 years ago Posts: 638 |
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 14, 2016 02:16PM |
Registered: 9 years ago Posts: 23 |
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 15, 2016 09:00AM |
Registered: 8 years ago Posts: 10 |
Quote
NeilFrazerLX
It's sorted now. Just needed to reset and re-load the page.
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 15, 2016 12:30PM |
Registered: 9 years ago Posts: 23 |
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 15, 2016 12:52PM |
Registered: 9 years ago Posts: 1,159 |
Quote
ncmreynolds
Quote
NeilFrazerLX
It's sorted now. Just needed to reset and re-load the page.
Sorry, what exactly was the issue?
I've just built a new printer and it works fine through Pronterface but the Web interface seems totally flaky and is mostly unresponsive, failing to update at all unless you disconnnect/reconnect much like you've described. I can move the nozzle around and look at the contents of the SD card but that's about it. Printing from SD worked once to do the calibration piece and then not again. Pushing pretty much any button apart from Connect/Disconnect doesn't seem to do anything.
I've tried both Chrome and Edge on Windows 10 and get similar behaviour.
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 15, 2016 03:31PM |
Registered: 9 years ago Posts: 1,699 |
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 15, 2016 03:53PM |
Registered: 10 years ago Posts: 14,672 |
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 15, 2016 06:35PM |
Registered: 10 years ago Posts: 665 |
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 16, 2016 05:50AM |
Registered: 8 years ago Posts: 10 |
Re: Web interface not updating, 1.09m-Dc42 and 1.07 January 16, 2016 09:43AM |
Registered: 10 years ago Posts: 14,672 |