Ladies and gents,


Long story short I've managed to send 12v into the sensor and of course I was greeted with celebratory fireworks here.

Hence only one component seems to be blown this should be 2min fix, of course if only I would be able to tell what was the component.

Anyone could point me into the right direction?!

Much appreciated in advance.


Kris



Edited 1 time(s). Last edit at 03/02/2022 04:10PM by kr15_uk.

I have a 4-pin Ormerod proximity sensor and it includes a 10uF 10V tantalum capacitor. My best guess is that it is the same component that has failed in your 3-pin sensor. It's likely failed short circuit, which is why the PCB traces are burned. Are they still intact?

If you are in the UK as your username suggests, I could send you my 4-pin proximity sensor if you PM me your address

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].