Welcome! Log In Create A New Profile


Arduino mega2560 not working

Arduino mega2560 not working
August 01, 2016 12:31AM
I have recently started building a 3d printer that is very loosely based around the prusa i3, while I was setting up the electronics i plugged the ramps 1.4 board into the arduino mega and all the stepper drivers into the ramps 1.4. I plugged the ramps into the power supply (Xbox 360 power brick, constant 12 volts) and then the arduino turned on and then the ON led faded off. I read some forums and tried removing the d1 diode. I plugged the arduino into 5V USB and it still did the same thing (watch video).

If you need anymore information just ask

Any sort of help will be greatly appreciated

Sorry, only registered users may post in this forum.

Click here to login