New to 3D printing. 1st print clogged nozzle? April 16, 2015 03:46PM |
Registered: 9 years ago Posts: 2 |
Re: New to 3D printing. 1st print clogged nozzle? April 19, 2015 01:11AM |
Registered: 11 years ago Posts: 469 |
Re: New to 3D printing. 1st print clogged nozzle? April 19, 2015 01:58AM |
Registered: 9 years ago Posts: 49 |
Re: New to 3D printing. 1st print clogged nozzle? April 19, 2015 06:49AM |
Registered: 9 years ago Posts: 286 |
Re: New to 3D printing. 1st print clogged nozzle? April 21, 2015 03:57PM |
Registered: 9 years ago Posts: 2 |
Quote
Im not 100% sure of the type of extruder body you have but it looks like the retainer clip that holds the bowden tube has come out. See picture below. It is obviously critical that this end of the bowden tube is firmly secure in the extruder body
Re: New to 3D printing. 1st print clogged nozzle? April 21, 2015 09:47PM |
Registered: 11 years ago Posts: 469 |
Quote
gleegum
Quote
Im not 100% sure of the type of extruder body you have but it looks like the retainer clip that holds the bowden tube has come out. See picture below. It is obviously critical that this end of the bowden tube is firmly secure in the extruder body
I see,
the instructions for assembly this part (in fact the whole video) was a piece of sh*t.
I didn't know that clip was for that.
reprap.cn is really bad quality parts.