Welcome! Log In Create A New Profile


Suitable stepper?

Posted by David_Wallis 
Suitable stepper?
February 22, 2016 05:33PM
Are these ok for a p3 Steel?


Thinking 6 so can run dual bowden extruder or at least have a spare.

Re: Suitable stepper?
February 24, 2016 09:32AM
I got similar ones (if not the same):
So rating is 1.7A, this should be more than enough. My steppers aren't even warm after printing 2-3 hours. And think about your stepper drivers: If you use A4988 drivers they can give you max 1A (without special cooling) so you'll drive them only to max 2/3 of their power.
So yes, they are more than ok!
Re: Suitable stepper?
February 24, 2016 05:36PM
Sorry, only registered users may post in this forum.

Click here to login