Welcome! Log In Create A New Profile



Posted by charlieRC 
July 27, 2019 12:47PM
I tried to setup baby stepping on Marlin 1.1x and getting an error

SENDING:M290 Z0.05
echo:Unknown command: "M290 Z0.05"
SENDING:M290 Z-0.05
echo:Unknown command: "M290 Z-0.05"
Has marlin dropped support for baby stepping or is there something more I should be doing.

If I haven’t screwed it up yet, I’m not thinking hard enough!

CoreXY, Titan Aero, Duet WiFi, custom design and build
Cartesian, E3D v6 hotend, Bondtech QR extruder, custom design and build
Re: babystepping
July 27, 2019 01:02PM
... could be, you have to set a define for babystepping, to enable the M-code ...

Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]
Re: babystepping
July 27, 2019 02:36PM
In Marlin 1.1.X baby stepping is allowed if it is enabled in configuration_adv.h


Electronics Technician / Computer Programmer
Sorry, only registered users may post in this forum.

Click here to login