E0 it's Not working..SKR v1.3

Can't get my E0 - E1 to work
I have received 2 death 2130 drivers, so i am trying to run my SKR 1.3 bort like..

#define X_DRIVER_TYPE TMC2130_STANDALONE
#define Y_DRIVER_TYPE TMC2130_STANDALONE
#define Z_DRIVER_TYPE A4988
#define E0_DRIVER_TYPE A4988

XYZ is working
If i swap the Z cable with E cable extruder stepper motor runs fine.
I have also tried switching the drivers around but it's still the same socket that is not working E0. Drivers and cabels is fine.

Is it a jumper settings issue ?
Can i fix it in Marlin and where?

Please Please help me

Did you set a hot end temperature? E will not move unless the hot end is hot...

how did you test this? sending gcode? clicking on extrude button somewhere?

I have tunde off the temp stop for E, and using Pronterface
Driver send one puls to E stepper motor (motor E is under torque) and then nothing

Edited 3 time(s). Last edit at 12/05/2019 09:57PM by Oleolsen.

Did you mount the stepper driver in the right direction? You can try to use E1 maybe, if E1 works you immediately know the board is defective. Also, did you swap the cable while the board was turned on? Or swap drivers while the board was on?

Edited 1 time(s). Last edit at 12/06/2019 02:25AM by Ohmarinus.

---

http://www.marinusdebeer.nl/

E0 to E1 do i haf to remap all the pins to test it, or is there a easy way ?
And what is the correct settings for the jumpers under TMC2130 in STANDALONE Mode, i don't have any jumpers in at all now ?
Always power off ;-)

I hope this helps, it looks like you short all jumpers for TMC2130
[wiki.fysetc.com]

My bord is a SKR1.3 maybe it's the same settings as FYSETC F6, the do not show my jumpersestings for TMC2130_STANDALONE... only SPI mode
Anyone no have to set the jumpers for TMC2130_STANDALONE ?