Question about duet firmware features April 29, 2016 05:49PM |
Registered: 7 years ago Posts: 14 |
Re: Question about duet firmware features April 30, 2016 07:26AM |
Registered: 8 years ago Posts: 475 |
Re: Question about duet firmware features April 30, 2016 07:27AM |
Registered: 10 years ago Posts: 14,672 |
Re: Question about duet firmware features April 30, 2016 08:01AM |
Registered: 8 years ago Posts: 475 |
Re: Question about duet firmware features April 30, 2016 08:07AM |
Registered: 10 years ago Posts: 14,672 |
Quote
PRZ
David, as yet M581 & M582 commands are not yet implemented, may I suggest you to use 'G' as trigger parameter qualifier instead of 'T' commonly used for tool ?
Also, (but If I understood, that was implemented by DC Newman), a 'N' as qualifier for M569 enable may have been more understandable than 'R'.
Also, 'H' is used either for heater and height, but there is a lot of legacy here, so probably too late for a change.
Re: Question about duet firmware features April 30, 2016 08:30AM |
Registered: 8 years ago Posts: 475 |
Re: Question about duet firmware features April 30, 2016 10:26AM |
Registered: 7 years ago Posts: 14 |
Quote
dc42
Hi,
RepRapFirmware doesn't have an filament odometer or printing time accumulator, and I don't recall anyone asking for these features before. Do you have a specific application for them?
Babystepping is on the wish list and will be implemented soon. Filament out sensor support is in the process of being implemented, and codes M581 and M582 have been allocated to support it (see [reprap.org]).
There is no TCP port provided for direct printing. I would be very concerned about the lack of security if such a port were provided.
HTH David
Re: Question about duet firmware features April 30, 2016 10:46AM |
Registered: 7 years ago Posts: 14 |
Quote
PRZ
David, as yet M581 & M582 commands are not yet implemented, may I suggest you to use 'G' as trigger parameter qualifier instead of 'T' commonly used for tool ?
Also, (but If I understood, that was implemented by DC Newman), a 'N' as qualifier for M569 enable may have been more understandable than 'R'.
Also, 'H' is used either for heater and height, but there is a lot of legacy here, so probably too late for a change.
Re: Question about duet firmware features April 30, 2016 07:30PM |
Registered: 8 years ago Posts: 177 |
Re: Question about duet firmware features May 03, 2016 04:55AM |
Registered: 10 years ago Posts: 665 |
Quote
dc42
There is no TCP port provided for direct printing. I would be very concerned about the lack of security if such a port were provided.