model cooling fan and z min pins on Duet 0.65 April 30, 2016 06:17PM |
Registered: 11 years ago Posts: 805 |
Re: model cooling fan and z min pins on Duet 0.65 May 02, 2016 10:02AM |
Registered: 9 years ago Posts: 177 |
Re: model cooling fan and z min pins on Duet 0.65 May 02, 2016 10:14AM |
Registered: 8 years ago Posts: 475 |
Re: model cooling fan and z min pins on Duet 0.65 May 02, 2016 12:22PM |
Registered: 10 years ago Posts: 14,672 |
Quote
sungod3k
Hi,
im trying to get my Duet 0.65 another go on my delta after it shorting on me last time i have a new one now and I remember the only extensive writing about it was on the reprap pro page, which still exists but doesnt give a complete picture of the what goes where. Motors and normal endstops are covered, but Im missing the placement of the hotend cooling fan, the model cooling fan and the z min endstop for my bed level probe.
Is there another non-omerod resource or manual for the duet 0.65? because I really dont want to wreck the board again by trying to figure out the 5V pins for the hotend cooling fan and slip and short something
Cheers