Duet and Delta - where to mount? December 29, 2016 02:49AM |
Registered: 9 years ago Posts: 1,699 |
Re: Duet and Delta - where to mount? December 29, 2016 07:11AM |
Registered: 8 years ago Posts: 117 |
Re: Duet and Delta - where to mount? December 29, 2016 01:16PM |
Registered: 10 years ago Posts: 14,672 |
Re: Duet and Delta - where to mount? December 29, 2016 01:21PM |
Registered: 9 years ago Posts: 1,699 |
Re: Duet and Delta - where to mount? December 29, 2016 03:10PM |
Registered: 8 years ago Posts: 117 |
Re: Duet and Delta - where to mount? December 29, 2016 03:43PM |
Registered: 9 years ago Posts: 1,699 |
Re: Duet and Delta - where to mount? December 30, 2016 03:46PM |
Registered: 10 years ago Posts: 14,672 |
Quote
Teilchen
The print with ABS is still running (since 8hours) and the temperatures seem to be stable. 40C inside the electronics bay, 60C at the CPU (according to DWC).
Quote
Teilchen
Is there a way to know if there was a stepper driver reset or overtemp? I notice there is something like "skipped steps" in M122 report? Why does the minimum Temp of the CPU is jumping dependent on when you execute M122?
Quote
Treito
Strange thing that happens at me: Sometimes after a print the Delta is not homed anymore even though there is a G28 command at the end of the print. Skipped steps?