I can't seem to get my slic3r settings right for 100 or even 150 microns. I use the same settings for 450 down to 200 microns and all my prints come out great. At 150 or 100 microns, my external perimeters look pretty good. However, my infill is piling up and then the nozzle is bumping over it layer after layer. I tried to play around with the advanced settings but I don't really know what Iby nrandal - General
Electronics Board powering your rig? LED to show power delivery to HPB? Continuity and voltage check at wire hook ups for HPB? Active cooling to power transistors?by nrandal - General
If someone already said this sorry. I believe if you are using repetier you can add a @pause with a message to remind you what you need to do.by nrandal - General
I have been looking for a solution to ABS peeling for a while. Frankly the best solution I found to relieve stress was to switch PLA. PLA on glass with a light coating of hairspray and the bed heated to 70C has been failsafe for me. I get 100% hold rates even for tall parts with small surface areas. Then I found out purely by accidental laziness and oversight that parts stick to the same placby nrandal - Reprappers
Setup: Hadron, MBE single Sainsmart Ramps 1.4 using Arduino Mega. I am using Repetier firmware and host. I have been printing for two weeks now without a hitch until last night. Mid print the filament stopped extruding. The reason is because the hot end shut off, the heater bed did as well. Repetier host shows them both turned ON for heating but the temperatures are dropping. Both LEDs haveby nrandal - RAMPS Electronics