Ya i did. I didn't set the motherboard to the correct one and now it is working fineby printer_man58 - Reprappers
I am using pronterface(mac) and am trying to get my printer to callibrate. The only problem is that on pronterface none of the motors will move and the extruder and bed aren't heating up. But when I use the reprap test code all the motors move fine and the bed and extruder heat up. Any help would be greatly appreciated. Thanksby printer_man58 - Reprappers
My firmware is the exact same except i think you are missing a lin which is right here // Disable max endstops for compatibility with endstop checking routine #if defined(COREXY) && !defined(DISABLE_MAX_ENDSTOPS) #define DISABLE_MAX_ENDSTOPS #endif and when it is asking if you are using a direct drive or geared extruder which i am pretty sure i am using a geared extruderby printer_man58 - General
I saw your blog Chris33 and i saw how you placed the endstops and that is exactly how i put them on my board and it still wont show any difference if ive pressed the endstop or not,by printer_man58 - General
Even after I added that bit about disabling max endstops the code still shows them all triggered. This is what it looks like when i have only pressed the z axis endstop but not the other 2n SENDING:M119 Reporting endstop status x_min: TRIGGERED y_min: TRIGGERED z_min: TRIGGEREDby printer_man58 - General
Thanks alot shadowram and chris 33. could you also tell me where the signal and ground pins are to see if i put them correctlyby printer_man58 - General
Thanks for the help, but when I tried changing it to false something else happened. Now in pronterface it shows the endstops as triggered even though i haven't pressed anything. Any other help would be greatly appreciated. Thanksby printer_man58 - General
Hi I am fairly new to using marlin software and my endstops don't seem to be working. I typed in the m119 command in pronterface to show my endstop details but it always show them open even after i pressed them. Here is my code // Uncomment the following line to enable CoreXY kinematics //#define COREXY // coarse Endstop Settings #define ENDSTOPPULLUPS // Comment this out (using // at the startby printer_man58 - General