yep. but I'm having a few problems... the x and y motors are not working now... grrrr.by jtreg - Delta Machines
Hello all, I have had some issues with my Tevo Little Monster, this question is about the TFT28; I load gcode files onto SD card and I tried with the same on USB stick. Looking at either SD Card or U List do I see any files, the menu stays on the FileSys option. Please help. Many thanks Jamesby jtreg - Controllers
Hi Waitaki I swapped t1to t0 still shows incorrect temp. I have abandoned the graphics board for now still no joy... Even replaced the thermistor.by jtreg - Reprappers
Hi all, I connected up a new RepRapDIscount Full Graphics controller up to my Ramps 1.4 (I have a Prusa i3). All was hunky dory (for the last year, actually) - I noticed the conroller showed up the bed reading temp at 73-74 degrees C at room temperature. No heat until I raided the threshold above 74... I did uncomment the necessary 2 lines in Marlin to get Graphics controller working, that was aby jtreg - Reprappers
Yep all sorted now but I have posted another issue regarding the bed thermistor which is playing up after I plugged in the Graphics controller. A hell of a coincidence as I have been using my pribter for a year with no problems until now!by jtreg - RAMPS Electronics
I have Ramps board. Is there documentation to hook the Graphics controller up please? I dont want to blow it up! The Ramps board has only one 8 pin connector. The LCD controller has 2 connectorsby jtreg - RAMPS Electronics
Hi I hope this is the best place to pose my problem, I have been using my Rumba board with no problem using my Macbook to print. I have recently fitted end stops and heated bed, all worked perfectly. Today, I noticed my heated bed thermistor read incorrectly and I tried connecting to no avail, I get error unable to connect to usb port. I still can connect to Rumba board to upload and modify Marby jtreg - RAMPS Electronics