I set the endstop gamma to 460 and it being it down close to it, not set the bed up yet to find tune it. Still working on it. Stay tuned for more details as I learn.by Zukduk - Controllers
I have it working had to rewire motors till it worked have them backwards but reversed in firmware. Now the hot end will not go low enough to reach bed, where do I set the bed height? Don't have the z probe anymore.by Zukduk - Controllers
How do I change the amps in firmware is it in the configuration.txt file....Am I supposed to have one end stop per axis or two board has x,y,z+++ and x,y,z--- I have 3 of them in positive positions.by Zukduk - Controllers
I have purchased a mks sbase 1.2v board for my kossel 2020 got everything connected, got newest firmware, (i think) kossel delta config file. hit the home in repetier and pontier and all it does is jitter the motors no real movement. Where can i find a step by step build for a delta kossel for this board or can someone help. I am decent with electronics and think i have everything wired right....by Zukduk - Controllers
I havent printed on anything other than the stock bedwhich is aluminum heated bed....the mask is a simple solution to covering the bed quick and easy...beats running strips to cover the bed. And yes ther is other solutions to how you prep your bed, but not everyone knows anything different yet. Like me im a newbie and will learn in time....thanx for the info about the other preps maybe one day iby Zukduk - General
Hello 3d world i am a newbee 3d'er and i found that using painters tape is a hassel to apply being i can only find 2'' tape.....well i found a better solution....VINYL GRAHICS MASKING. (TRANSFER MASK) I have a 220mm print bed and i use 6" and 12" mask for my bed....one swipe and done. Plus it lasts thru several prints and sticks very well until i scrap a hole in it removing a part. TRY IT OUT YOby Zukduk - General
Hello 3d world i am a newbee 3d'er and i found that using painters tape is a hassel to apply being i can only find 2'' tape.....well i found a better solution....VINYL GRAHICS MASKING. I have a 220mm print bed and i use 6" and 12" mask for my bed....one swipe and done. Plus it lasts thru several prints until i scrap a hole in it removing a part. TRY IT OUT YOU MIGHT LIKE IT. And its cheaper in tby Zukduk - Printing
I have everything built to specs, finally figured out the probe settings (to work) when I get my bed leveled in arduino I will run the probe (g29) ,start the print and into the bed in some spots it goes, does the z probe not take care of this? Measurement on my bed is very close to equilibrium in 6 points x,y,z and inbetween.... I am using the kossel Rev b firmware from build site. It didn't havby Zukduk - Delta Machines
I recently bought a kossel 2020 as my first 3d printer which was a mistake... And i cant get it to stay consistent for nothing....finally got the z probe working and i dont think it does anything for me still hits bed while printing in some areas...does anyone have a working firmwar w for this printer that i can load.... I am not learning how to 3d print. Im learning how to cus in different languby Zukduk - Delta Machines