It's worth a shot. Thanks, Ramon!by tgmelo - General
Hello, everyone. I'm having trouble with some missing lines in the raprap full graphic smart controller. It works just fine with my other printer, so it's not the LCD. I'm using the classic arduino 2560 + ramps 1.4 combo. Yes, I've included the U8glib library, and it is the last version downloaded on github. The Marlin is a copy from the previous working one aside from mechanical settings. I'veby tgmelo - General
I bought a laser head that I connected to the d9 output, but it's ON from the start. It doesn't respond to any Gcode command to turn it off or decrease power. And yes, 13_EFB. The PMW works fine for my layer fan. I've checked everywhere but I cannot find an answer. The company that sold me the unit isn't of much help either. They say it worked fine on their printers and the unit was tested beforeby tgmelo - Laser Cutter Working Group
Thanks ggherbaz! Lost the resistors and plugged into the 5V out in the board. Working fine!by tgmelo - Reprappers
Hi there, I use a MKS Gen V1.3 , also having problems with sensor wired to it. It was working fine on my ramps 1.4, but since I moved to the GEN, it just does´t stops the Z axis anymore. Is it safe to plug the Brown cable direct to one 5V output on the GEN? thanks,by tgmelo - Reprappers
Yes, I know. D10 is the one not working. The issue with the bed is different. Maybe it is something wrong with my firmware settings. I wonder if I should change something in the other tabs. Some people change the configurations on pins.h but I don't know if the sources are reliable enough.by tgmelo - RAMPS Electronics
Sorry if I wasn't more specific. As I stated, I don't know much about electronics. I'm using pronterface and when I set the temperature for the extruder, the LED on ramps lights up but the extruder remains cold. Then when I measure the output on D10 it reads 0. The problem with the bed is different. The bed is heating and it shows on the LCD display but pronterface is reading ambient temperature.by tgmelo - RAMPS Electronics
Hello. This is my first post. Hope you guys can help me. I have a ramps 1.4 with mega 2560 At this point when I send the command, it heats up the bed but the temperature doesn’t read on pronterface or cura. The hot end does not respond, and it's reading the room temperature. The red light in on. On the multimeter D08 it reads 11,40 and both D09 and D10 reads 0 Note: I know next to nothing about eby tgmelo - RAMPS Electronics