Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 10 of 10
yep, its confirmed that the problem is on my board/firmware.
i replace it with a newer board it runs great with repetier, thanks again for the help Mr.repetier
by
malsais
-
Repetier
super slow that im having is it move like a underpower pc playing graphic intense games, laggy. it stops for 3 seconds and move normal for 1 second and increasingly become slower and finally stop. everything at speed multiply is at 100%
however if Increase my speed on the fly using repetier slider, it will move normally longer but eventually will stop also.
previously i said that printing other
by
malsais
-
Repetier
everything looks fine for me, maybe you have a better eye on gcode
by
malsais
-
Repetier
forgot to mention, im using Repetier-Host Windows 0.84
by
malsais
-
Repetier
Hi,
after i install repetier, i connect it to my printer and everything on moving manual is great.
load existing gcode that i have sliced weeks ago, prints great.
but when i slice it with internal slic3r ( usually i just print without any config change on slic3r) it will print very sloow and after a few second it just stop.. anyone know the problem? I've tried speed up the first layer speed with
by
malsais
-
Repetier
Hi, I have the same mintemp issue and wantto set my own mintemp, i follow the tutorial on this site http://the3dprinter.blogspot.com/2012/02/durbie-prusa-mendel-calibration.html] and after i define the mintemp number that i want in configuratio.h , then when I want to verify/compile, an error message that i dont understand shows up
any help on this? thanks in advance!
by
malsais
-
Firmware - experimental, borrowed, and future
Hi,
I usually use printrun as my host and recently was trying to use repetier host, I found the GUI was quite good and thinking to give it a try.
load my stl and try to generate gcode with it and it shows error (screenshot attached)
anyone know whats my mistake? tried it with different stl and found no luck;
thanks!
by
malsais
-
Repetier
if he add features like realtime 3d viewport and support material control, it will be perfect!
by
malsais
-
Slic3r
Here is a video about the error on my durbie prusa mendel, the board is gen6d , any clue will be greatly appreciated , I'm really frustrated (
http://www.youtube.com/watch?v=5hDhgvbuqVM
by
malsais
-
RepRap Host
Hi,
I've test my reprap printer to run my first printing and it work well, and the next day I try to make another print and it act weird, it keep sending message as if i connect and disconnect in most of the time if i move my axis through pronterface. it also says "echo:Invalid extruderworkDir open failed" and everytime i send a command to my printer, it always show a message "valid extruder"
a
by
malsais
-
RepRap Host