Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 9 of 9
@AndrewBCN,
Could you please describe the changes that are depicted in each of the pictures above? I find the pictures are not enough to adequately understand what is being done.
Thank you!
by
NickE
-
RAMPS Electronics
Teacup now supports Delta Kinematics!
Today, I was able to successfully do a test print using Teacup.
It is only the lowly 15mm test cube done at 30mm/s, but it is the culmination of many hours of effort.
I know, I know - without evidence, it didn't happen:
YouTube
Also see attached picture of the finished test cube.
Rudimentary LCD support for the RepRapDiscount Smart Controller has also b
by
NickE
-
Firmware - experimental, borrowed, and future
Either of the two below work for the Reprapdiscount Full Graphic Smart Controller on the RAMPS1.4/Mega
SCK = 23, MOSI = 17, CS = 16 (corresponding to the Mega's Pins).
Uncomment one the two lines from the sketch.
//U8GLIB_ST7920_128X64_1X u8g(23, 17, 16); // SPI Com: SCK = en = 18, MOSI = rw = 16, CS = di = 17
//U8GLIB_ST7920_128X64_4X u8g(23, 17, 16); // SPI Com: SCK = en = 18, MOSI = rw = 1
by
NickE
-
RAMPS Electronics
@dc42 and @ambrop7,
Looking at your firmwares, I am trying to get the flow of what is happening, but it looks like it will take hours of code analysis
Can you please give me a simple flowchart or pseudocode of the steps being taken to calculate the step times?
I would appreciate it very much!
by
NickE
-
Firmware - experimental, borrowed, and future
I have been using my Reprapdiscount Smart Controller since last May with no difficulties. During a print, the display changed (see attached image) to where the first two lines are fine, but the last two lines show blanks for the first 8 characters and white blocks for the last 12 characters. The menu still functions normally (except you have to know or guess what you cannot see). The SDCard pa
by
NickE
-
Controllers
Although this guy is using the Megatronics 2.0 instead of RAMPS, there might be something there useful for your quest:
Custom controller with SSD1311 I2C OLED
by
NickE
-
Firmware - mainstream and related support
I bought some red and blue filament from this ebay supplier: .
It was supposed to be 1.75mm ABS. The boxes the spools came in were marked as:
ABS 1.75/BLUE/140115ABS002 and ABS 1.75/RED/130819ABS008
but the spools themselves were not. The spools were vacuum sealed.
The filament, however, is not (as far as I can tell) ABS or PLA. It prints very well at ABS profile with extrusion at 230C and h
by
NickE
-
Plastic Extruder Working Group