Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 13 of 13
Ok it is working now, thank you for your interest
by
dominate
-
General
no software on pc, i only use lcd. I print from sd card
by
dominate
-
General
Hello,
I use marlin firmware for my DIY 3d printer. I want to put a menu item that move heatedbed to the lower position which is 120 mm. I used the below menu item but didint work. Could anyone help me why below doesnt work?
MENU_ITEM(gcode, "Go Lower", PSTR("G1 X0.0 Y0.0 Z120.0"));
by
dominate
-
General
Thank u very much
by
dominate
-
General
Hello,
On my DIY 3d printer i am using bowden extruder. For my previous printer i used normal extruder and DEFAULT_AXIS_STEPS_PER_UNIT for extruder was 100. Now for my bowden extruder configuration which steps/mm i should use for the extruder?
by
dominate
-
General
Hello,
I am using Marlin firmware in my 3d printer. I can see the remaning time on repetier software gui. But I want to display the remaning time on LCD when i print from sd card. Is it possible to display it on LCD? I think in Gcode there is no remaning time information so how can i take this information? Could anyone help me?
by
dominate
-
Firmware - experimental, borrowed, and future
Hello,
I use PLA 220 degree for the first layer and 210 degree for other layers. Heatbed temperature is 65 degree. And i have the problem of warping of the corner of the shape. what should i do to solve this problem? Another problem is after some time the printing material doesnt stick to the heatbed so the printing fails
by
dominate
-
General
Hello,
I made my first 3d printer. I made x, y, z and extruder calibration. The problem is when i print a material which have holes on it, hole diameter is smaller than the original size. What can be the problem? I use repetier host and marlin firmware, Slic3r for slicer.
by
dominate
-
Printing
Thanks for replies, i calibrated extruder. I will calibrate more accurate the z axis and try again one more time.
by
dominate
-
Printing
By the way when nozzle starts printing, it doesnt touch material. But when it goes up it starts to touch the material.
by
dominate
-
Printing
Hello,
I finished my first 3d printer. Now it works well after calibration of xyz axes and the extruder. My problem is, the upper nozzle goes, the closer the nozzle to the material. And at the end it touches the material. I used 0.4 mm nozzle so for each height, i increase z axis by 0.4 mm. Should i increase more than 0.4 mm? or my z calibration is not good enough so this problem occured. What i
by
dominate
-
Printing
I have got pin problem on my lcd so i have just tried this line and it is working now . Thank u very much NickE
by
dominate
-
RAMPS Electronics
Hello,
I am new at here. I want to integrate Ramps 1.4 with Reprapdiscount Graphic Controller and Arduino Mega. I want to write hello world. I found hello world example from u8glib library. But here i should uncomment constructor of u8glib. Which constructor i should use for reprapdiscount full graphic smart controller? I uncomment below line but doesnt work :/
//U8GLIB_ST7920_128X64_1X u8g(8,
by
dominate
-
RAMPS Electronics